Molded PTFE Rod Thick 6mm - 660mm

Category: PTFE Products Suppliers
Product Code:

Molded PTFE Rod


Availability:In Stock

PTFE Rod is manufactured in two distinct ways, extruded PTFE Rod is the most popular and is relevant to smaller sizes, Moulded PTFE Rod is relevant to the diameters over 100mm in size, smaller sizes are also available in extruded form.


Molded PTFE rod is generally used as machining stock for all kinds of chemical, electrical and mechanical components where the outstanding performance characteristics of PTFE are required. Various fillers are available to modify the properties of PTFE to meet application requirements.

Fluoro-Plastics compression molds rods and cylinders for machining in a wide range of sizes. The most common sizes are listed in the table below, but many other combinations of OD and ID are available.  Molded rods are preferred for machining because compression molding yields greater material homogeneity for the finished part.

All rods can be etched for bonding, and can be mounted on a plywood disk for less waste in machining.

All rods can be made with filled (reinforced) PTFE to enhance the performance parameters of PTFE. Materials available for reinforcement are Glass Fiber, Carbon, Graphite, Bronze, Molybdenum Disulfide, and Stainless Steel.

Specification:(mm)

6*100 48*300 140*300 380*200
8*100 50*300 150*300 408*300
10*100 52*300 160*300 453*200
12*100 55*300 165*300 516.5*120
13*100 60*300 170*300 565*200
14*150 65*300 180*300 610*200
15*150 68*300 190*300 660*120
16*150 70*300 200*360 100*1000
18*150 75*300 210*250 110*1000
20*300 80*300 220*300 120*1000
22*120 85*300 230*200 130*1000
24.5*140 90*300 240*250 140*1000
25*300 95*300 250*300 150*1000
27*150 100*300 262*200 160*1000
28*120 108*200 270*150 170*1000
30*300 110*300 280*300 180*1000
32*150 120*300 315*400 200*1000
35*300 125*300 336*300 250*1000
40*300 130*300 347*200 300*1000
45*300 134*200 360*300  

Write a review

Your Name:
Your Review:
Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: